HP 460 G7Blade

Home Forums Other General Hardware HP 460 G7Blade

This topic contains 6 replies, has 3 voices, and was last updated by Avatar anna25 7 years, 7 months ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • Avatar
    ldev
    Member
    #158166

    Just plugged a brand new HP460G7 Blade into enclosure and get the following error.

    iLO network configuration problem, check connectivity to iLO default gateway

    I have reset the ilo
    It is active *hit f8 on startup*
    Model iLo3
    Firmware version 1.28

    OA firmware 3.31

    tehcamel
    tehcamel
    Moderator
    #358739

    Re: HP 460 G7Blade

    …. have you set a network configuration on your ilo?
    have you checked that it’s right?

    Avatar
    anna25
    Member
    #385198

    Re: HP 460 G7Blade

    yes I have.. its set to dhcp.

    tehcamel
    tehcamel
    Moderator
    #358746

    Re: HP 460 G7Blade

    ok. is it getting a dhcp address?

    Avatar
    anna25
    Member
    #385199

    Re: HP 460 G7Blade

    No, it says aquiring ip.

    tehcamel
    tehcamel
    Moderator
    #358748

    Re: HP 460 G7Blade

    I’m fairly rough on blade infrastructure. I do knwo it doesn’t have it’s own ethernet port though.. it connects to a mezzanine card or something, right?

    If you try it in a different blade slot, does the same problem happen?
    What about a different blade in that slot, does it get an ip address?

    Avatar
    anna25
    Member
    #385200

    Re: HP 460 G7Blade

    we have 2 enclosures so I plugged it into the older enclosure with older firmware and it works fine.

    Wierd…HP says its a firmware issue and needs to be upgraded..but why would it work on the older firmware????

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.