Announcement

Collapse
No announcement yet.

Static Route Configuration

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Static Route Configuration

    Hi All,

    I currently have a 2K8 Failover Cluster configured which will have multiple resources listening on different subnets. Below is the setup:

    Cluster IP - 10.10.10.10/24 GW 10.10.10.1
    Node01 IP - 10.10.10.11/24 GW 10.10.10.1
    Node02 IP - 10.10.10.12/24 GW 10.10.10.1
    Resource 1 IP - 10.10.10.13/24 GW 10.10.10.1
    Resource 2 IP - 10.10.20.11/24

    The issue I am having is what static route entry do I add for Resource 2 to have a gateway to route traffic off of its network? There is a third subnet (10.10.30.0/24) that hold our DC and DNS rolls for which Resource 2 needs to be able to communicate with to be brought online.

    Any help is greatly appreciated.

    TIA,

    -Jason
    MCSA/MCSE 2K3,MCITP:ESA,MCTS x 4,VCP x 2

  • #2
    Re: Static Route Configuration

    Well I figured it out! Mods can close this thread if need be.

    When I was adding the static route I was using the following:

    route add -p 0.0.0.0 mask 0.0.0.0 10.10.20.1 IF 10.10.20.11

    What I specifying incorrectly was the interface (the IF 10.10.20.11). What I need was the interface ID number. Using the following command I was able to discover that:

    netsh int ipv4 show int

    Once I had the ID number the new route add statement looked like the following:

    route add -p 0.0.0.0 mask 0.0.0.0 10.10.20.1 IF 34

    Issue resolved!

    -Jason
    MCSA/MCSE 2K3,MCITP:ESA,MCTS x 4,VCP x 2

    Comment

    Working...
    X