Announcement

Collapse
No announcement yet.

HP 460 G7Blade

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • HP 460 G7Blade

    Just plugged a brand new HP460G7 Blade into enclosure and get the following error.

    iLO network configuration problem, check connectivity to iLO default gateway

    I have reset the ilo
    It is active *hit f8 on startup*
    Model iLo3
    Firmware version 1.28


    OA firmware 3.31

  • #2
    Re: HP 460 G7Blade

    .... have you set a network configuration on your ilo?
    have you checked that it's right?

    sigpic


    Please do show your appreciation to those who assist you by leaving Rep Point

    Comment


    • #3
      Re: HP 460 G7Blade

      yes I have.. its set to dhcp.

      Comment


      • #4
        Re: HP 460 G7Blade

        ok. is it getting a dhcp address?

        sigpic


        Please do show your appreciation to those who assist you by leaving Rep Point

        Comment


        • #5
          Re: HP 460 G7Blade

          No, it says aquiring ip.

          Comment


          • #6
            Re: HP 460 G7Blade

            I'm fairly rough on blade infrastructure. I do knwo it doesn't have it's own ethernet port though.. it connects to a mezzanine card or something, right?

            If you try it in a different blade slot, does the same problem happen?
            What about a different blade in that slot, does it get an ip address?

            sigpic


            Please do show your appreciation to those who assist you by leaving Rep Point

            Comment


            • #7
              Re: HP 460 G7Blade

              we have 2 enclosures so I plugged it into the older enclosure with older firmware and it works fine.

              Wierd...HP says its a firmware issue and needs to be upgraded..but why would it work on the older firmware????

              Comment

              Working...
              X