Announcement

Collapse
No announcement yet.

5510 Static Routing

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • 5510 Static Routing

    hello,
    new to the routing of a 5510... can i setup some static routes that the 5510 will redirect to appropriate internal network? they are behind the same gateway but on different networks. trying to avoid having to do static routes on the workstations.
    thanks

  • #2
    Re: 5510 Static Routing

    If I understand your post correctly, all models of the ASA support adding static routes.

    On your 5510, lets say the interface that connects to the gateway is named "inside" and is configured with an ip address of 10.10.10.1/255.255.255.0. The gateway ip address to the other networks is 10.10.10.4. The networks that can be reached via the gateway are 10.10.20.0/255.255.255.0 and 10.10.30.0/255.255.255.0.

    To add static routes to these networks on the 5510, your would add:

    route inside 10.10.20.0 255.255.255.0 10.10.10.4
    route inside 10.10.30.0 255.255.255.0 10.10.10.4

    Comment


    • #3
      Re: 5510 Static Routing

      thanks, are these settings live when programmed?

      i will most likely use the ASDM and then save to running if it works.

      is there a log one can use to monitor these routes?

      Comment


      • #4
        Re: 5510 Static Routing

        can't seem to get this working.
        i have 192.168.123.x network trying to get to 192.168.1.x network. there is no router between them, just the cisco 5510.

        Comment


        • #5
          Re: 5510 Static Routing

          the asa 5510 can do sub interfaces and you can configure each subinterface for the vlans those networks are in.

          then you can do global or static configurations

          static (inside,DMZ1) 192.168.123.0 192.168.123.0 netmask 255.255.255.0

          Comment

          Working...
          X