Announcement

Collapse
No announcement yet.

Natting on a PIX

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Natting on a PIX

    Hey Guys,

    This is a pretty basic question, but for the life of me, i can't seem to figure it out. I'm more of a Checkpoint guy, not a pix... so any help would be appreciated.

    I'm trying make a pretty simple NAT... I'm trying to Hide NAT an internal network to a specific IP on the DMZ. So anytime someone comes from 'inside' from a subnet, going to the DMZ, all requests will come from that specific IP.

    I'm trying to establish this on a pix version 6.3(4)

    Just an example of what i'm looking for:

    Internal Networks i want to NAT, located on the 'inside' interface:
    10.10.0.0/16

    DMZ Network:
    192.168.1.0

    Translated Address i would like to see when any traffic from the above networks go to the DMZ:
    192.168.1.5
    I don't want this to apply to any other intefaces except for this.

    Any help would be greatly appreciated.

    have a good one!
    thanks!

    -jay

  • #2
    Re: Natting on a PIX

    This will help you...
    http://www.cisco.com/en/US/products/...800b6e1a.shtml
    Marcel
    Technical Consultant
    Netherlands
    http://www.phetios.com
    http://blog.nessus.nl

    MCITP(EA, SA), MCSA/E 2003:Security, CCNA, SNAF, DCUCI, CCSA/E/E+ (R60), VCP4/5, NCDA, NCIE - SAN, NCIE - BR, EMCPE
    "No matter how secure, there is always the human factor."

    "Enjoy life today, tomorrow may never come."
    "If you're going through hell, keep going. ~Winston Churchill"

    Comment

    Working...
    X