No announcement yet.

2611 and ADSL DHCP

  • Filter
  • Time
  • Show
Clear All
new posts

  • 2611 and ADSL DHCP

    I have a 2611 with two ehternet (LAN) ports an 1ADSL Card and a 1ENET Wan Card

    here's my version info
    IOS (tm) C2600 Software (C2600-I-M), Version 12.2(26), RELEASE SOFTWARE (fc2)
    Copyright (c) 1986-2004 by cisco Systems, Inc.
    Compiled Sat 31-Jul-04 04:57 by eaarmas
    Image text-base: 0x8000808C, data-base: 0x80A1E540

    ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

    DMGRouter0 uptime is 53 minutes
    System returned to ROM by power-on
    System image file is "flash:c2600-i-mz.122-26.bin"

    cisco 2611 (MPC860) processor (revision 0x203) with 28672K/4096K bytes of memory.
    Processor board ID JAD05370KQ6 (2533697732)
    M860 processor: part number 0, mask 49
    Bridging software.
    X.25 software, Version 3.0.0.
    2 Ethernet/IEEE 802.3 interface(s)
    32K bytes of non-volatile configuration memory.
    16384K bytes of processor board System flash (Read/Write)

    Here's my goal I'd like to do DHCP for two networks, a and a (one on each lan port)
    I'd like to use the dsl card to replace the Actiontec m1000 POS

    The router isn't showing the WIC cards in config

    I'd like to do port forwarding

    I have a static IP from CentruryLink

    I'm running several servers on the 10.3.xx and an access point, printers and such on the 192.168xx

    I'd like to get rid of the Actiontec, and the wrt300 that's handling the 192.168.xx

    I have a VLAN set up already for each network on a 2950..

    Can this be done?