No announcement yet.

multiple vlans cisco 2960-s

  • Filter
  • Time
  • Show
Clear All
new posts

  • multiple vlans cisco 2960-s

    Had a recent cisco voip install and now currently doing a hyper-v and storage network install. However the only free ports we have are on the voice switch. The ports were all configured like this

    interface GigabitEthernet1/0/1
    description user workstations
    switchport voice vlan 10
    srr-queue bandwidth share 1 30 35 5
    priority-queue out
    mls qos trust device cisco-phone
    mls qos trust cos
    auto qos voip cisco-phone
    spanning-tree portfast
    service-policy input AUTOQOS-SRND4-CISCOPHONE-POLICY

    I created a sub interface on router for an Iscsi Vlan (vlan 5) and the trunk port includes that vlan, can i add that vlan to the interfaces that i have the san/servers plugged in without removing all the voice stuff?

  • #2
    Re: multiple vlans cisco 2960-s

    There is no reason to have the voice vlan config on a switchport that isn't going to have a phone connected to it. I would remove it:

    default interface gi1/0/1

    int gi1/0/1
    switchport mode access
    switchport access vlan 5
    spanning-tree portfast
    spanning-tree bpdu-guard enable
    CCNA, CCNA-Security, CCNP
    CCIE Security (In Progress)