No announcement yet.

Cisco 800

  • Filter
  • Time
  • Show
Clear All
new posts

  • Cisco 800

    HI I have a cisco 800 adsl modem. For one or other reason I am not able to connect to it through HyperTerminal. When I set up hyperterminal and connect I am only getting a _ that is flashing? My Hyper terminal settings is on a com port with bir rate 9600, data bits 8, parity none, Stop bits 1, flow control hardware. The RJ45 to serial cable was made by cisco cabling code.

    On my router both the RXD and TXD is flasing fast. Is this normal?
    Last edited by ONE2ONE; 7th June 2012, 13:18.

  • #2
    Re: Cisco 800

    Try setting flow control to "none". Also are you connecting the rollover directly to a serial port on your pc or are you using a serial to usb adapter? I dont use hyperterminal at all and mostly stick to putty for console sessions. Also check and make sure your using the correct com port.

    Here is a link from cisco:
    CCNA, CCNA-Security, CCNP
    CCIE Security (In Progress)