Announcement

Collapse
No announcement yet.

Help with 1751-v router and wic-4esw configuration not saving

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Help with 1751-v router and wic-4esw configuration not saving

    I have a 1751-v router and wic-4esw 4 ethernet port switch card.
    I am trying to configure the card as a 4 port switch with a single ip address by vlan.

    When configuring the Fastethernet interface, the terminal takes the following comands, but does not save them.

    When I type:
    Code:
    conf t
    int fa0/1
    switchport mode access
    switchport access vlan 1
    exit
    show run int fa0/1
    I get the interface back with no configuration saved:
    Code:
    interface fastethernet 0/1
    !
    I am running the following release:
    Code:
    c1700-k9o3sv8y7-mz.124-25d
    I am not getting any errors back, the card is properly detected in a show inventory, and I've tried a different firmware, a different router, and a different card.

    The only configuration command that "sticks" is shutdown and no shutdown.

    Does anybody know why my configuration is not being saved???
    This is driving me crazy, please help.

    Thanks,
    Vittorio

  • #2
    Re: Help with 1751-v router and wic-4esw configuration not saving

    This is normal. Most IOS "default" commands will NOT be displayed when using "show run".

    Comment


    • #3
      Re: Help with 1751-v router and wic-4esw configuration not saving

      You are very right.
      The switch interface was not working and I thought it was because the interface was not taking the configurations. The switch card was not working because I had not configured the vlan database.
      Still not very sure what the vlan database is for.
      The vlan 1 interface did in fact exist.

      Comment

      Working...
      X