No announcement yet.

Erase flash from Cisco Switch

  • Filter
  • Time
  • Show
Clear All
new posts

  • Erase flash from Cisco Switch

    Hi everyone,
    I have not too long started the CCNA class and am doing the lab on routers and switches...they are fasinating and I am taking the learning quite well....sometimes I have ? and I go to goolge or Jeremy teaching but this one I am not succeding. I TELNET from School using their routers and switches....on one of the switch I erase the flash or dir flash because the fa that I had conf was not showing on the switch, so I wanted the switch to be at the original so I can see the difference with it.........well, now its just showing switch:
    should I just reset?
    Its not taking any command....only the question mark...with all the commands that can be done.

    Thanks for any response. I have been at it all day trying to medicate it....
    Not to forget I don't have access to the switch to switch it off. Also I am hesitant to ask the teacher...he already has little time for us.
    Yours in distress.
    Ms. Zef
    Last edited by Zef; 7th May 2011, 04:57.