Announcement

Collapse
No announcement yet.

Factory reset for Cisco Aironet 1000 series Access Point

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Factory reset for Cisco Aironet 1000 series Access Point

    Hi,

    I bought a couple of second hand Cisco Aironet 1000 series Access Point (AIR-AP1010-N-K9.
    How can I access confguration page as I dont know the IP address of the units because they seems changed from factory settings.
    Is there any hard reset method?

    Regards

  • #2
    Re: Factory reset for Cisco Aironet 1000 series Access Point

    Using the MODE Button

    Follow these steps to delete the current configuration and return all access point settings to the factory defaults using the MODE button:
    Step 1 Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point.
    Step 2 Press and hold the MODE button while you reconnect power to the access point.
    Step 3 Hold the MODE button until the Status LED turns amber (approximately 2 to 3 seconds), and release the button.
    Step 4 After the access point reboots, you must reconfigure the access point by using the Web browser interface, the Telnet interface, or Cisco IOS commands

    Ref: http://www.cisco.com/en/US/docs/wire...html#wp1057541
    Caesar's cipher - 3

    ZKHQ BRX HYHQWXDOOB GHFLSKHU WKLV BRX ZLOO UHDOLVH LW ZDV D ZDVWH RI WLPH!

    SFX JNRS FC U6 MNGR

    Comment


    • #3
      Re: Factory reset for Cisco Aironet 1000 series Access Point

      Hi,

      This model has no Mode button. Actually there is no any button on the case either on power adapter.



      Last edited by quazar; 31st March 2010, 22:43.

      Comment

      Working...
      X