Announcement

Collapse
No announcement yet.

Getting a Cisco Aironet 1200 series working on a specific VLAN...

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Getting a Cisco Aironet 1200 series working on a specific VLAN...

    Hello,
    I have a Cisco Catalyst 2950 XL Layer Three switch that I am trying to connect with a Cisco Aironet 1200 Series Access Point. The switch is connected to other switches throughout the campus and the campus has several VLANs defined on our distribution switch (A Cisco Catalyst 4506 switch with routing capabilities). The configuration for that system is attached as 4506.txt.
    The Cisco Catalyst 2950 XL switch is attached as 2950.txt and the AP is attached as AP.txt.
    The 2950 switch on FastEthernet Port 0/24 is connected to the larger 4506 switch at port FastEthernet 3/1.
    The AP is connected to the 2950 switch on port FastEthernet 0/17.
    The problem is that I need the AP to operate on VLAN 60 but the AP is ONLY operating on VLAN 10.
    If I switch a port on the 2950 to VLAN 60 I can plug a laptop into that port and access that VLAN but the AP cannot do so.
    What am I doing wrong? Thank you for your time.
    Regards,
    Christopher Koeber
    Attached Files

  • #2
    Re: Getting a Cisco Aironet 1200 series working on a specific VLAN...

    Give the 4506 an ip address on vlan interface 60

    Ex:
    interface Vlan60
    ip address 10.10.60.1 255.255.255.0
    ip helper-address 10.10.1.110


    See if that works.
    CCNA, Network+

    Comment


    • #3
      Re: Getting a Cisco Aironet 1200 series working on a specific VLAN...

      Unfortunately it doesn't. Do I restart the devices?

      Attached is the new configuration for the 4506 where the VLANs are defined.

      Thank you for your time.

      Regards,
      Christopher Koeber
      Attached Files

      Comment


      • #4
        Re: Getting a Cisco Aironet 1200 series working on a specific VLAN...

        Ok, try this. I just looked at my Aironet 1100, only my BVI1 interface has an ip address. So remove the Dot11Radio0, and FastEthernet0 ip's.
        CCNA, Network+

        Comment

        Working...
        X