Announcement

Collapse
No announcement yet.

Eigrp not working?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Eigrp not working?

    cisco gurus,
    Im trying to setup Eigrp protocol on two routers via point to point through serial 0.0. Ive set the AS as the same group and entered in the networks. But when i try to show the neighborhood i cant see anything?...its not exchanging any packets at all?...ANy help will be great..ive been at this for hours and figure id try it out on here...

    i have basically router A setup as 192.1.59.1 with point to point to 192.1.57.1 through serial 0/0 and under networks ive entered 192.1.0.0.



    thanks,
    Allen
    Last edited by fusioneclipse; 26th March 2009, 04:48.

  • #2
    Re: Eigrp not working?

    hi
    check:
    1) if you enter the networks under eigrp process .
    2) you should use ip add from the same subnet in the point to point interface.
    3) use the same AS on both routers.
    ofer

    Comment


    • #3
      Re: Eigrp not working?

      Post your config here (make sure to blank out any sensitive info). Also, both routers can't route for the same network. Router 59.1 can't say "to get to 192.1.0.0 go through me" and router 57.1 say "to get to network 192.1.0.0 go through me" both at the same time. You could have router 59.1 say "to get to network 192.1.0.0/16 go through me" and have router 57.1 say "to get to network 192.2.0.0/16 go through me".

      Comment

      Working...
      X