No announcement yet.

Catalyst 3560 DMZ

  • Filter
  • Time
  • Show
Clear All
new posts

  • Catalyst 3560 DMZ

    I have catalyst switch 3560 and central router cisco 2801. I have to configure DMZ. Problem is that some IP ranges of 192.168.X.X I am using for regional offices. They are passing through ISP router (not under my control) towards regional offices (MPLS).

    The software in 3560:

    Cisco IOS Software, C3560 Software (C3560-IPBASE-M), Version 12.2(35)SE5, RELEAS
    E SOFTWARE (fc1).

    I am not sure that route-map commands are supported for the above Cisco IOS. In fact I was told not completely. I planned to use this command to separate traffic for the internet (public addresses) and private addresses for regional offices.

    Now the problem is that I do not have these commands under my disposal.

    What am I going to use instead?

    In fact how the MPLS firewall is solved?