Announcement

Collapse
No announcement yet.

Controller E1 status reset

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Controller E1 status reset

    Hello all,

    One of the router I manage has its controller E-1 interface in reset mode.

    My first thought is that it was a Layer one related issue (cable, modem or even the DSU), the fact is that I've checked it with the carrier, I have placed a local and a remote logical loopback on the controller, even a physical loopback on the router and on the modem...the interfaces went up...so everything seems to be ok from carrier's side, I even have change the wic card ....the issue remains the same.

    I'd like to have your thought about this

    model :

    Cisco Internetwork Operating System Software
    IOS (tm) C2600 Software (C2600-JS-M), Version 12.3(19), RELEASE SOFTWARE (fc2)

    sho controller e1
    E1 0/0 is down.
    Applique type is Channelized E1 - balanced
    Transmitter is sending remote alarm.
    Receiver has loss of frame.
    alarm-trigger is not set
    Version info Firmware: 20051006, FPGA: 20, spm_count = 0
    Framing is CRC4, Line Code is HDB3, Clock Source is Line.
    CRC Threshold is 320. Reported from firmware is 320.
    Data in current interval (542 seconds elapsed):
    0 Line Code Violations, 0 Path Code Violations
    0 Slip Secs, 542 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
    0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 542 Unavail Secs
    Total Data (last 24 hours)
    43477 Line Code Violations, 59 Path Code Violations,
    0 Slip Secs, 83973 Fr Loss Secs, 30 Line Err Secs, 0 Degraded Mins,
    0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 83978 Unavail Secs

    show int des :

    Se0/0:0 reset down


    Thank you and have a good day
    Last edited by cameleon001l; 12th August 2008, 12:37.

  • #2
    Re: Controller E1 status reset

    looks like both are down.
    Can you post the show run and the show int

    also have you give both interfaces a no shut?
    Marcel
    Technical Consultant
    Netherlands
    http://www.phetios.com
    http://blog.nessus.nl

    MCITP(EA, SA), MCSA/E 2003:Security, CCNA, SNAF, DCUCI, CCSA/E/E+ (R60), VCP4/5, NCDA, NCIE - SAN, NCIE - BR, EMCPE
    "No matter how secure, there is always the human factor."

    "Enjoy life today, tomorrow may never come."
    "If you're going through hell, keep going. ~Winston Churchill"

    Comment

    Working...
    X