Announcement

Collapse
No announcement yet.

What is username and password for Catalyst 2950 web access?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • What is username and password for Catalyst 2950 web access?

    I have configured Catalyst 2950 switch and assigned IP address to it through consol cable(connected to COM2 through my PC).
    I gave the switch IP address:192.168.5.1 with 255.255.255.0 subnet mask.
    Then I configured my PC's NIC card with 192.168.5.2/24.
    I can ping both PC and switch from each other.

    Now I wanted to see how the web interface of that switch look like but when I type http://192.168.5.1 it pop-up window and ask for username and password. it says level 15 access.

    any idea?
    Thanks,
    Data Sheet

  • #2
    Re: What is username and password for Catalyst 2950 web access?

    Hi datasheet,
    What ever password you have configured for privilage mode, use that password. You would not be able to access web interface of your switch if you have not configured privilage password.
    well for setting privilage password is
    enable password cisco
    if you already set the password and you do not remember what was your password use comand
    show running config --- this comand will run in privilage mode.
    so you user name will be administrator here and password would be password you set up in privilage mode. some of cisco device come with default password.
    the user name for default password is administrator and password is password or cisco some time. so give it try too.
    Cheers

    Comment


    • #3
      Re: What is username and password for Catalyst 2950 web access?

      I got it. The username is cisco and password is what I choose.
      I got into Cisco Cluster Management Suite and can see front panel of switch and other good stuff.

      Thanks,
      Data Sheet

      Comment

      Working...
      X